See what is really flowing through your water
Most sites measure parameters (flow, pH, conductivity), not substances. We add fine-grained, continuous measurement, right where the water is.
From inlet to outlet
Measure, analyze, report
Measure
Microfluidic microscopy: particles, fibers, microorganisms, microplastics, combined with physico-chemistry and UV-Vis indicators. Heavy metals and PFAS: in qualification.
Analyze
AI analyzes images on site: counts, sizes and trends. Monitoring reveals variations.
Report
Indicators, alerts and exportable data, sent to your client portal (Ethernet, Wi-Fi or 4G depending on configuration).
What we measure today, and tomorrow
We only offer what we can demonstrate: each capability is shown with its actual status.
Particles and fibers
Counts, size distributions, morphometry; natural and synthetic fibers.
Microplastics
Counts, size distributions.
Microorganisms
Microalgae, cyanobacteria and other biological content.
Physico-chemistry
Flow, pH, conductivity, BOD, TSS, temperature, dissolved oxygen, redox potential.
UV-Vis optical indicators
Turbidity, color, UV254 (organic load), UV280 (biological signal).
Monitoring
Trends, history, anomaly detection, alerts.
Heavy metals
Cadmium (Cd), mercury (Hg), lead (Pb), arsenic (As), nickel (Ni), chromium (Cr), copper (Cu), zinc (Zn).
PFAS
Per- and polyfluoroalkyl substances.
Measurement-driven treatment
Chemical dosing, aeration and biological monitoring driven by measurement: validated site by site during the pilot.
Bacteriological indicators
E. coli and indicators required for the intended reuse: laboratory analyses, continuous monitoring to be validated during the pilot.
COFRAC accreditation for water testing
Accreditation is being prepared for a defined scope of methods and parameters. COFRAC is the French accreditation body.
Measurements you can base decisions on
Every result stays linked to the conditions under which it was produced.
Identified
Instrument, sampling point, protocol and standard used.
Timestamped and located
Timestamp, geolocation and calibration reference attached to every reading.
Autonomous
On-site analysis with no permanent connection required, then transmission to remote monitoring.
Complementary
Works alongside your sensors and laboratory analyses, without replacing them.
Do you really know the quality of your water, at process inlet and outlet?
Let's start with a water audit: a site-specific assessment to identify your savings potential and define the right solution.